Update 29-3-16

Bit of an update on the current state of projects, things have slowed down a lot during summer as I have been working on a lot more things outside, with the weather cooling down now work on some inside/electronic projects can begin again.

The mysql, weather station and temp sensors have all been working well with now over 300,000 data points giving per minute data points on most for now just shy of twelve months.

Overall database size has grown to around 140mb for the whole set of sensors.

dbsize

The laundry fan has been installed and added to one of the relay boards and both DHT22 sensors have been mounted. One in the laundry and one in the bathroom.

Laundry Fan with DHT22
Laundry Fan with DHT22
Bathroom fan with DHT22
Bathroom fan with DHT22

The RFID system on the front door as also been working flawlessly now for almost 18 months with 1750 entries during that time.

webpage

 

The outdoor sensor array still hasn’t quite made it from it’s temp cardboard home however the final two sensors have arrived

The Sharp GP2Y1010AU0F dust sensor and the ML8511 UV sensor.  So now I can at least finish off the software side on the Arduino and do final testing before finding a case and mounting it outside.

DSC_0214

 

Doorbell camera has also stopped working. Not sure if it’s just a corrupt SD-Card in the Raspberry Pi if it’s gotten a bit too hot over summer and cooked, going to take it down in the next few days and find out.

Another project that has been collecting dust for a while now is a MAME arcade machine I started sometime back. Needs a couple of new joysticks, a tidy up and probably a new PC to drive it as the one in there is a little under powered and generates a lot of heat.

Some cable management would go astray either 😛

DSC_0209

DSC_0220

Leave a Reply

Your email address will not be published. Required fields are marked *